4" Flat Flashing
This flashing is constructed of an all stainless base and upstand
4" FLAT FLASHING
The flat flashing is used to weather proof your roof once the flue has been fitted and nests under the tiles on your roof
This flashing is constructed of an all stainless base and upstand
You place your roof tiles back into place making sure you leave the bottom edge of the flashing above the tiles so the rain will run onto the lower tiles and disperse
Â
Please Be Advised:
You will require a Storm Collar when installing your flashing to cover the air gap between the top of the flashing and the flue pipe once installed
The hole on this flashing will be 6" external diameter, to match the external diameter of the 6" twin wall. Do note that the hole may be a bit larger than 6" and the purchase of a storm collar is required in addition to the flashing.
Designation | EN1856-1 T450 N1 D V3- L50040 G60, EN1856-1 T600 N1 D VM- L20040 G70 |
---|---|
Construction | Stainless Steel |
Inner Material: | 316 Grade 0.40mm Thick Stainless Steel |
Outer Material: | 304 Grade 0.40mm Thick Stainless Steel |
Fuels: | Wood, Oil, Gas, Low Sulpher Coal |
Approvals | HETAS, CE |
Warranty: | 25 years |
Notice: | Our Twin Wall products are not compatible with any other Twin Wall Flue System and cannot be used with any other Brand. |
Outer Diameter | 150mm |
Installation Guide
Our twin wall insulated flue is a simple push fit joint system. To create and maintain a continuous length, the twin wall pieces push together and with the aid of a locking band (provided with each length) secure the connection between each piece. The push fit system remains the easiest method of installation to date
We recommend that all installations are carried out by a qualified chimney installer.
additional information on installation and requirements can be found below.
 Download Document J Regulations
Â
Â
Â