7" Gas Suspending Cowl
The suspending cowl is designed to hold the liner at the top of your chimney stack by securing itself to a chimney pot
7" GAS SUSPENDING COWL (STAINLESS STEEL)
The suspending cowl is designed to hold the liner at the top of your chimney stack by securing itself to a chimney pot
It is supplied with two jubilee clips, one for the corresponding size of liner that you require, and the other to clamp around the chimney pot.
The mesh is ½ inch square suitable for gas applications.
The suspending cowl will accommodate up to a 305mm diameter potÂ
| Construction | Stainless Steel |
|---|---|
| Inner Material: | 0.7mm Stainless Steel |
| Fuels: | Gas & Oil (28 Sec) |
| Approvals | HETAS Approved |
| Outer Diameter | - |
Installation Guide
Suspending cowl, With the liner protruding from the chimney pot push the sleeve inside the liner, the three straps attached to the sleeve are then secured to the flexible liner with a fastening strap, now continue pushing the liner inside the pot until the base of the suspending cowl rests on top, now bend the three outer straps down the outside of pot and secure with the second fastening strap.
We recommend that all installations are carried out by a qualified chimney installer.
additional information on installation and requirements can be found below.
 
Download Document J Regulations
Â
Â
Â